Programming Instructions
Note: Entering the programming mode cancels all learned keyless
remotes, so none of the previously programmed remotes will work. You must
reprogram all of the keyless remotes once you are in the programming mode.
You must complete each step within 4 seconds of the previous
step to keep the system from exiting the programming mode. You must program
remotes within 10 seconds of each other
1. Turn ignition switch to ON (II)
2. Within 4 seconds press the LOCK or UNOCK button on one of
the remotes.
(An unprogrammed remote can be used for this step.)
3. Within 4 seconds turn ignition switch to LOCK (0)
position
4. Within 4 seconds turn the ignition switch to ON (II)
5. Repeat steps 2, 3 and 4 two more times using the same
keyless remote used in step 2
6. Within 4 seconds press the LOCK or UNLOCK button on the
same remote. Make sure the power door
locks cycle to confirm you are in programming mode.
7. Within 10 seconds press the LOCK or UNLOCK button on same
remote.
8. Within 10 seconds press the LOCK or UNLOCK button on all
other remotes you want to program. Make sure door locks cycle after you push
each remote button to confirm system has accepted the remote.
9. Turn the igniton switch to LOCK (0) to exit programming
mode.
10. Test remote(s)
If you need a Locksmith to program this remote or for any
other locksmith needs please call +23481-026-544-20 within Nigeria.
No comments:
Post a Comment